Page History

Prior to testing, Pearson recommends confirming that each student testing device is configured properly and has adequate bandwidth.  This page does not pertain to tests managed in ADAM. Ask your Assessment Coordinator or Pearson Delivery Team if you are unsure what content on this page applies to your setup.

Run

Network Check

1. Launch TestNav on the student device.

2. Select App Check.
   Image Modified




3. 
   

4. Click Run Network Check.
   Image Added
   

5. Estimate the number of devices that will connect to your network during testing, and enter it into the Number of devices field.
   Image Added
   

6. Click Start Diagnostics Test.

7. View Test Results under Network Diagnostics to determine whether your network has sufficient bandwidth to test. Note: Any reference to 'ProctorCache' applies only to installations using PAN rather than ADAM.

   Image Added

   
   

1. Select Run App Check.
   Image Added
   

2. When the app check completes, review the results. Green checkboxes for Kiosk Mode readiness and connectivity to TestNav display if the system passes. If one of these fails, a message indicates you must check your connection and settings before running App Check again.
   .Image Added
3. Repeat check on other student devices.
4. Additional step for
5. If ProctorCache connectivity (or blocklist compliance) fail, TestNav provides information for possible resolutions.
For
6. PAN installations only (not ADAM): If you have obtained a Configuration Identifier from your assessment management system, enter it in the Configuration Identifier field on the App Check page. 

   The configuration identifier allows TestNav to also check connection to ProctorCache computers. If your assessment management system allows, this configuration ID may also check for blocklist compliance.

 

7. If ProctorCache connectivity (or blocklist compliance) fail, TestNav provides information for possible resolutions.
   
   

8. Select Run App Check.
   
   

9. When the app check completes, review the results. Green checkboxes for Kiosk Mode readiness and connectivity to TestNav display if the system passes. If one of these fails, a message indicates you must check your connection and settings before running App Check again.
   .
10. Repeat check on other student devices.

Run Network Check

On the App Check page:

1. Click Run Network Check.

   Image Removed

2. Estimate the number of devices that will connect to your network during testing, and enter it into the Number of devices field.
   

   Image Removed

3. Click Start Diagnostics Test.

See your Test Results under Network Diagnostics to determine whether your network has sufficient bandwidth to test without ProctorCache.


Image Removed