Page History

Prior to testing, Pearson recommends confirming that each student testing device is configured properly and has adequate bandwidth. Ask your Assessment Coordinator or Pearson Delivery Team if you are unsure what content on this page applies to your setup.

. The App Check is essential to run on each student testing device.

1. Launch TestNav on the student device.

2. Select App Check.
   Image Modified




3. Click Run Network Check.
   Image Removed
   

4. Estimate the number of devices that will connect to your network during testing, and enter it into the Number of devices field.
   Image Removed
   

Click Start Diagnostics Test.

5. 
   

6. View Test Results under Network Diagnostics to determine whether your network has sufficient bandwidth to test. Note: Any reference to 'ProctorCache' applies only to installations using PAN rather than ADAM.
   Image Removed
   

7. 
   

   • Additional step for
PAN
8. • PearsonAccessNext installations only (not ADAM): If you have obtained a Configuration Identifier from your assessment management system, enter it in the Configuration Identifier field on the App Check page. 

     The configuration identifier allows TestNav to also check connection to ProctorCache computers. If your assessment management system allows, this configuration ID may also check for blocklist compliance. If ProctorCache connectivity (or blocklist compliance) fail, TestNav provides information for possible resolutions.
     
     

9. Select Run App Check.
   Image Modified
   
   

10. When the app check completes, review the results. Green checkboxes for Kiosk Mode readiness and connectivity to TestNav display if the system passes. If one of these fails, a message indicates you must check your connection and settings before running App Check again.
    .Image Modified

Run Network Check

The best way to ensure network capacity is to follow the guidelines in the Network Requirements and Guidelines page. The Network Check described here is essentially an internet speed test that divides the results by the number of testers entered. It will not take into account the distribution of students to hotspots, etc. It may be useful for PearsonAccessNext users who are trying to determine if Proctor Caching is needed.

1. Launch TestNav on the student device.

2. Select App Check.
   Image Added
   
   

3. Click Run Network Check.
   Image Added
   
   

4. Estimate the number of devices that will connect to your network during testing, and enter it into the Number of devices field.
   Image Added
   
   

5. Click Start Diagnostics Test.

6. View Test Results under Network Diagnostics to determine whether your network has sufficient bandwidth to test. Note: Any reference to 'ProctorCache' applies only to installations using PAN rather than ADAM.
   Image Added